Liquidation is the most common way to lose money on futures. It does not happen out of nowhere: it follows a simple formula, and you can calculate it before you open a trade. Below we explain how it works on Bybit.
What liquidation is
When you trade with leverage, part of the position is paid with your own money (the margin) and the rest is borrowed from the exchange. If the price moves against you and the loss eats almost all of the margin, the exchange force-closes the position so it does not go negative itself. That is liquidation.
For the trader the result is simple: the margin on that position is gone. What happens to the rest of your balance depends on the margin mode (see below).
How the liquidation price is calculated
A simplified formula for a long, ignoring fees and maintenance margin:
liquidation price ≈ entry price × (1 − 1 / leverage)
For a short: entry price × (1 + 1 / leverage).
Example: BTC trades at $100,000 and you open a 10x long worth $10,000 (margin $1,000). Here is how leverage moves the liquidation price for the same entry:
5x: about a 20% drop, liquidation near $80,000
10x: about a 10% drop, liquidation near $90,000
20x: about a 5% drop, liquidation near $95,000
50x: about a 2% drop, liquidation near $98,000
In practice liquidation comes slightly earlier than these numbers, because the exchange requires a maintenance margin (a minimum buffer) and fees are deducted. Bybit shows the exact liquidation price in the position card, so rely on that figure.
The takeaway from the list: at 50x an ordinary 2–3% daily move in Bitcoin is enough to knock you out.
Cross or isolated margin
Isolated margin. A fixed amount is assigned to the position. In the worst case you lose exactly that amount, and the rest of your balance is untouched.
Cross margin. Your whole account balance backs the positions. Liquidation comes later, but in the worst case everything on the account is lost.
Isolated is safer for beginners because the maximum loss is known in advance.
Why you can be liquidated even though the chart "did not get there"
Two common reasons:
Mark price instead of last price. The exchange uses a mark price (averaged across the market) for liquidation, not the last trade on the exchange itself. This protects against one-off price spikes, but the price on your chart and the price used for liquidation can differ slightly.
Fees and funding. They reduce your margin and move the liquidation price closer. We covered what they cost in our guide to Bybit fees.
6 rules that lower the risk
Pick leverage that keeps the liquidation price far from the market. For a beginner a reasonable range is 2–5x.
Set a stop-loss in advance. It must trigger before the price reaches liquidation, otherwise it is pointless.
Use isolated margin until you have experience.
Do not put a large share of your deposit into one trade. A common guideline is to risk 1–2% of the deposit per trade.
Watch the news and scheduled events. Macro data releases and sharp candles are the typical moments of mass liquidations.
Do not average down with leverage. Adding to a losing position pulls liquidation closer.
Practice without risk
Before trading real money, open a small position or use demo mode and look at the position card and its liquidation price. You can register on Bybit via our referral link, and trading through it earns you cashback from our service.
Get part of your trading fees back
Open the Telegram bot, link your exchange account and follow your cashback balance.
In short
Liquidation is the forced closing of a position when its margin runs out.
The higher the leverage, the closer the liquidation price. At 10x it is roughly −10%, at 50x roughly −2%.
Isolated margin limits the loss to the assigned amount, cross margin puts the whole balance at stake.
A stop-loss must sit before the liquidation price.
This is not investment advice. Leveraged trading carries a high risk of losing capital.



